Standard Programming Functions :

• Model Select – six model memory.
• Model Type – select airplane or heli programming in one transmitter.
• Servo Reversing – on all six channels.
• Dual Rate/Exponential – for ailerons, elevator and rudder.
• End Point Adjustment – fine-tunes servo throws on all six channels.
• Digital Trim – stores trim settings for each model for aileron, elevator, rudder and throttle.
• Fail Safe – a safety throttle setting in case of loss of transmitter signal.
• Battery Fail Safe – moves the throttle to a preset position when the airborne pack reaches 3.8V.
• Stick Mode – choose from Mode 1 through 4.
• Range Checking – Power Down reduces transmitter output power for up to one minute, allowing range checking from 50 paces away.
• Changeable Throttle Stick – select ratchet for airplanes or smooth for helis.
• Adjustable Stick Length – choose the length that suits your flying style.

Airplane-Specific Programming Functions:

• Wing Mixing – for flaperon, flap trim, V-tail and elevon.
• Trainer System – with the transmitter as either the master or student system. Compatible with other Futaba systems.
• Throttle Cut – pre-programmed for safely shutting off the engine.
• Programmable Mixing (1 & 2) – two different mixes allow any two channels to be combined.

Helicopter-Specific Programming Functions:

• 5-Point Normal and Idle Up Throttle/Pitch Curves.
• Throttle Hold – for autorotation.
• Revo (Revolution Mixing) – mixes rudder and pitch together.
• Gyro Mixing – two gyro gain settings can be programmed and selected during flight.
• Swash to Throttle Mixing – corrects slowing of the engine's speed caused by the swashplate.
• Swashplate Types – choose from 1S (independent aileron, pitch and elevator servos linked to the swashplate), 3S (120° CCPM), or 3E (90° CCPM).
• Swash AFR – Adjustable Function Rate, for use with 1S, 3S or 3E swash types.